The ECC83 (12AX7) Valve
This short article describes the ECC83 valve also known as the 12AX7.
The ECC83 (12AX7) valve is used in the preamplifier section of 99% of all valve guitar amplifiers. Usually there are between 2 and 5 ECC83 (12AX7) valves in the preamplifier section.
Firstly let’s sort out the confusion. ECC83 or 12AX7? They are identical. ECC83 is the British designation and 12AX7 the American. Since the Americans invented it (RCA in 1946) I guess it should really be called the 12AX7. (The initial “12” in the designator implies a 12-volt heater requirement; however, the tube has a centre-tapped heater so it can be used in either 6.3V or 12.6V heater circuits.)
What is The ECC83 (12AX7) Valve?
The reason the ECC83 (12AX7) valve is used so much is because it’s actually two identical valves in one envelope! So designers can get two gain stages using just one ECC83 valve.
In technical terms, the ECC83 (12AX7) valve is a “dual high gain triode”.
Let’s unpack that…
- ‘Dual’ – there are two valves in the one glass envelope.
- ‘High Gain’ – speaks for itself. The gain is about x100 although in practice a workable gain of 60 is achievable.
- ‘Triode’ – the ‘ode’ part refers to electrode. So each valve has 3 electrodes. A Cathode, an Anode and a Grid.
Pause for a moment and think how they pack all that into one 9-pin envelope! 6 pins immediately go to the anodes, cathodes and grids. But each valve also has a heater, so that would need another 4 pins. Hmm… 6+4=10 and we only have 9 pins!
So on the ECC83 (12AX7) valve they put the heaters in series and bring out the two ends and a centre tap. Neat – and only 9 pins. You can put 12V across both heaters, or 6V across the individual heaters and ground the centre tap.
What is The ECC83 (12AX7) Valve Used For?
In a guitar amplifier the ECC83 (12AX7) valve is used everywhere gain is needed. The ECC83 (12AX7) valve can’t do any ‘heavy lifting’ so it’s not man enough for the output stages which drive the speaker. You need a big power valve for that.
But in the stages of pre-amplification needed to raise the feeble guitar output to a sensible signal level, the ECC83 (12AX7) valve is used commonly.
There are other places you need gain in a guitar amplifier. Think of the reverb pan. A strong signal is sent down to the pan and it waggles a little electromagnet attached to the spring. So the spring waggles (like a ‘Slinky’). At the other end another small electromagnet is waggled by the spring and this is the reverb return signal. But it’s MUCH weaker than the one sent to the reverb pan. That’s a job for another stage of gain provided by an ECC83 (12AX7) valve
In some older Fenders, an ECC83 (12AX7) valve is used to provide the vibrato function too.
In a typical guitar amplifier you’ll have three ECC83 (12AX7) valves providing 6 stages of gain.
How does it work? See one of my other articles for that description!
If you want to buy ECC83 (12AX7) valve you can get them here: http://www.ampvalves.co.uk/product/ecc83/
